|
| Home | Forum | Search |
| eNotAlone > Health > Diets and Weight Loss > Recipes and Cooking |
|
Essentials of Cookery : Heat for Cooking, Part 2 Library of Cookery (Page 9 of 16) Its consumption can be stopped at once by closing off the supply, or it can be regulated as desired and in this way made to give the exact amount of heat required for the method of cookery adopted. Neither smoke nor soot is produced in burning gas if the burners of the gas stove are adjusted to admit the right amount of air, and no ashes nor refuse remain to be disposed of after gas has been burned. Because gas is so easily handled, good results can be obtained by those who have had very little experience in using it, and with study and practice results become uniform and gas proves to be an economical fuel. 55. Measurement of Gas. - Gas is measured by the cubic foot, and a definite price is charged for each 1,000 cubic feet. To determine the quantity used, it is passed through what is called a meter, which measures as the gas burns. It is important that each housewife be able to read the amount registered by the meter, so that she can compare her gas bill with the meter reading and therefore determine whether the charges are correct. If only the usual amount of gas has been consumed and the bill does not seem to be correct or is much larger than it has been previously, the matter should be reported to the proper authorities, for the meter may be out of order and in need of repair. | ||||||||||||||||||||||||||||||||||||||||||||
56. Reading a Gas Meter. - To register the quantity of gas that is consumed, a gas meter, is provided with three large dials, each of which has ten spaces over which the hand, or indicator, passes to indicate the amount of gas consumed, and with one small dial, around which the hand makes one revolution every time 2 cubic feet of gas is consumed. This small dial serves to tell whether gas is leaking when the stoves and lights are not turned on. Above each large dial is an arrow that points out the direction in which to read, the two outside ones reading toward the right and the center one toward the left; also, above each dial is lettered the quantity of gas that each dial registers, that at the right registering 1,000 cubic feet, that in the center 10,000 cubic feet, and that at the left 100,000 cubic feet. To read the dials, begin at the left, or the 100,000 dial, and read toward the right. In each instance, read the number over which the hand has passed last. For instance, when the hand lies between 5 and 6 on the left dial, 5 is read; on the center dial, when the hand lies between 5 and 6, 5 is read also; and on the right dial, when the hand lies between 2 and 3, the 2, which is really 200, is read. 57. To compute the quantity of gas used, the dials are read from left to right and the three readings are added. Then, in order to determine the quantity burned since the previous reading, the amount registered at that time, which is always stated on the gas bill, must be subtracted from the new reading. To illustrate the manner in which the cost of gas consumed may be determined, assume that gas costs 90 cents per 1,000 cubic feet, that the previous reading of the gas meter, say on May 15, was 52,600 cubic feet, and that on June 15 the meter registered. As was just explained, the left dial of the meter reads 5, the center dial 5, and the right dial 200. Therefore, put these figures down so that they follow one another, as 5-5-200. This means then that the reading on June 15 is 55,200 cubic feet. With this amount ascertained, subtract from it the previous reading, or 52,600 cubic feet, which will give 2,600 cubic feet, or the quantity of gas burned from May 15 to June 15. Since gas costs 90 cents per 1,000 cubic feet, the cost of the amount burned, or 2,600 cubic feet, may be estimated by dividing 2,600 cubic feet by 1,000 and multiplying the result by 90. 58. Prepayment Meters. - In many places, gas concerns install what are called prepayment meters; that is, meters in which the money is deposited before the gas is burned. Such meters register the consumption of the gas in the same way as the meters just mentioned, but they contain a receptacle for money. A coin, generally a quarter, is dropped into a slot leading to this receptacle, and the amount of gas sold for this sum is then permitted to pass through as it is needed. When this amount of gas has been burned, another coin must be inserted in the meter before more gas will be liberated. Kerosene 59. In communities where gas is not available, kerosene, which is produced by the refinement of petroleum, is used extensively as a fuel for cooking, especially in hot weather when the use of a coal or a wood stove adds materially to the discomfort of the person who does the cooking. Kerosene is burned in stoves especially designed for its use, and while it is a cheap fuel it is not always the same in quality. It contains water at all times, but sometimes the proportion of water is greater than at others. The greater the amount of water, the less fuel will be contained in each gallon of kerosene. The quality of kerosene can be determined by checking up the length of time the stove will burn on a specified quantity of each new purchase of it. Another product of the refinement of petroleum is gasoline. However, it is not used so extensively for fuel as kerosene, because it is more dangerous and more expensive. Electricity 60. The use of electricity for supplying heat for cooking is very popular in some homes, especially those which are properly wired, because of its convenience and cleanliness and the fact that the heat it produces can be applied direct. The first electrical cooking apparatus was introduced at the time of the World's Fair in Chicago, in 1892, and since that time rapid advancement has been made in the production of suitable apparatus for cooking electrically. Electricity would undoubtedly be in more general use today if it were possible to store it in the same way as artificial gas, but as yet no such method has been devised and its cost is therefore greater. Electricity is generated in large power plants, and as it is consumed in the home for lighting and cooking it passes through a meter, which indicates the quantity used in much the same manner as a gas meter. It will be well, therefore, to understand the way in which an electric meter is read, so that the bills for electricity can be checked. 61. Reading an Electric Meter. - An electric meter, which is similar in appearance to a gas meter, consists of three or four dials, which are placed side by side or in the shape of an arc. In the usual type and which consists of four dials placed side by side, each one of the dials contains ten spaces and a hand, or indicator, that passes over numbers ranging from to 9 to show the amount of electricity used.
|
| |||||||||||||||||||||||||||||||||||||||||||
|
© 2008 eNotAlone.com | ||||||||||||||||||||||||||||||||||||||||||||